Grey PU Coated Cut 5 Gloves

Description

Price

List Price ex.VAT £9.70
List price inc.VAT £11.64
£

Sizing

 Code SizeW x LQty
 SCAGLOCUT5M NEW M (8) 88 x 240mm 1 pair
 SCAGLOCUT5 L (9) 95 x 250mm 1 pair
 SCAGLOCUT5XL XL (10) 102 x 260mm 1 pair
 SCAGLOCUT5XX NEW XXL (11) 105 x 270mm 1 pair
Find a Stockist Size diagram

Certification

View Certificate UK Declaration of Conformity
EN 420: 2003+A1: 2009, EN 388:2016+A1:2018
View Certificate EU Declaration of Conformity
EN 420:2003, EN 388:2016+A1:2018

Catalogue page

Scan Catalogue Page 46pdf
Category image

Glove Selection Guide

Scan provide a range of gloves for protecting the hands with emphasis on the needs of workers in commercial industries where the combination of good protection and user comfort are main requirements.

Standard EN ISO 21420

The EN 420 standard was revised in March 2020 becoming standard​ EN ISO 21420: 2020​.

This standard defines the general requirements for protective gloves in terms of construction, fitness of purpose, safety, etc.

Standard EN388:2016

Providing protection for mechanical risks.

This standard applies to all kinds of protective gloves in respect of physical and mechanical aggressions caused by abrasion, blade cut, tearing, puncture and impact.

EN388 Example
4 = Abrasion Rating 1-4
5 = Blade Cut Rating 1-5
4 = Tear Rating 1-4
2 = Puncture Rating 1-4
C = 2nd Cut Rating A-F
P = Impact P Pass or Fail

Protection against mechanical risks is expressed by a pictogram followed by a number rating representing test performance against a specific risk. The performance level is from 1-5, where 4 or 5 is the best result. X = not tested. P = Impact test passed.

The level of performance is based on the number of cycles/force required to penetrate the sample.

A

Abrasion resistance: based on the number of cycles required to abrade through the sample glove.

B

Blade cut resistance: based on the number of cycles required to cut through the sample at a constant speed.

C

Tear resistance: based on the amount of force required to tear the sample.

D

Puncture resistance: based on the amount of force required to pierce the sample with a standard sized point.

E

2nd Cut resistance: based on the number of cycles required to cut through the sample.

F

Impact protection: the area of protection is secured over a domed anvil and is impacted at an impact energy of 5J.

View the full EN388 and Glove Selection Guide