Hi-Vis Gloves - Yellow

Glove Selection Guide

Scan provide a range of gloves for protecting the hands with emphasis on the needs of workers in commercial industries where the combination of good protection and user comfort are main requirements.

Standard EN420

This standard defines the general requirements for protective gloves in terms of construction, fitness of purpose, safety, etc.

Standard EN388:2016

This standard applies to all kinds of protective gloves in respect of physical and mechanical aggressions caused by abrasion, blade cut, tearing, puncture and impact.

Protection against mechanical risks is expressed by a pictogram followed by a number rating representing test performance against a specific risk. The performance level is from 1-5, where 4 or 5 is the best result. X = not tested. P = Impact test passed.

The level of performance is based on the number of cycles/force required to penetrate the sample.

	Abrasion resistance: based on the number of cycles required to abrade through the sample glove.
	Blade cut resistance: based on the number of cycles required to cut through the sample at a constant speed.
	Tear resistance: based on the amount of force required to tear the sample.
	Puncture resistance: based on the amount of force required to pierce the sample with a standard sized point.
	2nd Cut resistance: based on the number of cycles required to cut through the sample.
	Impact protection: the area of protection is secured over a domed anvil and is impacted at an impact energy of 5J.

View the full EN388 and Glove Selection Guide