All products > Gloves >

Vibration Resistant Latex Foam Gloves

Description

This anti-vibration, abrasion resistant glove is ideal for use with power tools and other equipment within industrial, agricultural or commercial environments.

The combination of a 7 gauge polyester outer with a cotton liner means this mixed shell glove can not only can absorb the wet well, but is also durable under all conditions.

The latex foam padding on palm absorbs vibration and the fingertip seams are glued for added resistance.

7g polyester shell with cotton liner
Latex foam padding on palm absorbs vibration
Glued fingertip seams
Conforms to EN420 and EN388

EN388 Mechanical hazard
1 = Abrasion 1-4
1 = Blade Cut 1-5
2 = Tear 1-4
x = Puncture 1-4
X = 2nd Cut A-F

Price

List Price ex.VAT	£4.09
List price inc.VAT	£4.91

€ £

Sizing

Code	Size	Qty
SCAGLOVRM	M (8)	1 pair
SCAGLOVRXL	XL (10)	1 pair
SCAGLOVRXX	XXL (11)	1 pair

Find a Stockist Size diagram

Certification

View Certificate	EU Declaration of Conformity EN420:2003+A1:2009, EN388:2016
View Certificate	UK Declaration of Conformity EN 420: 2003+A1: 2009, EN 388:2016+A1:2018

Catalogue page

Scan Catalogue Page 44 pdf

Standard EN ISO 21420

The EN 420 standard was revised in March 2020 becoming standard EN ISO 21420: 2020.

This standard defines the general requirements for protective gloves in terms of construction, fitness of purpose, safety, etc.

Standard EN388:2016

Providing protection for mechanical risks.

This standard applies to all kinds of protective gloves in respect of physical and mechanical aggressions caused by abrasion, blade cut, tearing, puncture and impact.

EN388 Example
1 = Abrasion Rating 1-4
1 = Blade Cut Rating 1-5
2 = Tear Rating 1-4
X = Puncture Rating 1-4
X = 2nd Cut Rating A-F
P = Impact P Pass or Fail

Protection against mechanical risks is expressed by a pictogram followed by a number rating representing test performance against a specific risk. The performance level is from 1-5, where 4 or 5 is the best result. X = not tested. P = Impact test passed.

The level of performance is based on the number of cycles/force required to penetrate the sample.

Abrasion resistance: based on the number of cycles required to abrade through the sample glove.

Blade cut resistance: based on the number of cycles required to cut through the sample at a constant speed.

Tear resistance: based on the amount of force required to tear the sample.

Puncture resistance: based on the amount of force required to pierce the sample with a standard sized point.

2nd Cut resistance: based on the number of cycles required to cut through the sample.

Impact protection: the area of protection is secured over a domed anvil and is impacted at an impact energy of 5J.